Disabling incoming program change?

Questions and Answers concerning the spectralis!

Moderator: Jörg Schaaf

Disabling incoming program change?

Postby ModularOverkill » Sun Jun 26, 2016 6:39 pm

When I change a patch on my controller board (UltraNova) it sends some kind of program change to the speckie, which then causes it zero out my current pattern and parts. Is there a way around this? The UltraNova doesn't have a send program ch on/off, and I couldn't find anything like this in the speckie manual or global settings.
Posts: 5
Joined: Sat Jun 25, 2016 1:51 pm

Return to Helpdesk

Who is online

Users browsing this forum: No registered users and 1 guest